找回密码
 FreeOZ用户注册
查看: 2743|回复: 2
打印 上一主题 下一主题

[发烧砌机] Antec Nine Hundred (MSY $193)

[复制链接]
跳转到指定楼层
1#
发表于 3-5-2009 18:55:56 | 只看该作者 回帖奖励 |倒序浏览 |阅读模式
提示: 作者被禁止或删除, 无法发言

马上注册,结交更多好友,享用更多功能,让你轻松玩转社区。

您需要 登录 才可以下载或查看,没有帐号?FreeOZ用户注册

x
The Nine Hundred is positioned by the manufacturer as a system casefor hardcore gamers. In this article it is an opponent to the P182. Itis a very big system case for a full-size mainboard, a lot of harddisks and, perhaps, a liquid cooling system. It is not the biggest,though. Antec’s line-up includes the Twelve Hundred model.
Thefront panel is occupied by meshed brackets for the 5-inch bays (nine intotal as the model name implies). You can see two 120mm fans throughthem. It is all very utilitarian, without any decorations. The P182looks far more stylish in comparison. Interestingly, the front panel isfree from any buttons. All of the buttons are located on the top panel.Like the above-discussed models, the Nine Hundred employs TriCool fanswith speed regulation. There is a translucent window in the center ofthe side panel. The side surface is also covered with a metallic meshnearby. It’s not quite clear where the manufacturer suggests the systemcase is placed. If on a desk, it won’t be easy to reach the buttons andports on the top panel. If on the floor, under the desk, why the window?
Interestingly,there is a translucent plastic panel underneath the mesh. It keepsalmost all the air from getting through the mesh. It is only in thecenter, between the two juts for fan fasteners, that there is a gapleft for the air to pass through. Well, if you don’t want to install anadditional fan, you can remove the plastic panel altogether.
Itis the top panel that is the most impressive in this system case. Theback half of it is all occupied by a huge 200mm fan. Being almost thesame width as the system case, the fan must have an enormousair-pumping capacity. This is a very important thing for gamers becauseit is in gaming systems that you find the best and the hottest graphicscards and CPUs. The back of the top panel being occupied by the fan,the PSU resides at the bottom while the mainboard has moved up alittle. The P182 has the same internal layout but the Nine Hundreddoesn’t have a separate compartment for the PSU as the former has.
The 200mm fan belongs to the TriCool series and features three-level speed regulation with the following parameters:

                               
登录/注册后可看大图
Thisgiant’s impeller creates a stronger airflow at 400rpm than a 120mm fandoes at 2000rpm. The level of noise being equal, the 200mm fan at400rpm is pumping through 2.5 times as much air as a 120mm fan at1200rpm.
Thebuttons and additional connectors populate the slanted front part ofthe top panel: Power and Reset buttons, a FireWire port, two USB ports,and two audio connectors.
There is a depression between thesecomponents and the fan. You can use it for various small PC-relatedthings such as flash drives.
Anice trifle: there is a special rubber pad at the bottom of thementioned depression to protect the plastic of the top panel fromscratches.

Notwithstandingthe 200mm giant in the top panel, there is an additional 120mm fan onthe back panel. If you’ve got a liquid cooling system with an externalradiator, you can use the two outputs for pipes.
The feet are made from ordinary rubber now.
Thechassis seems to be simple but as high quality as in the previousmodels. The only interesting thing here is the front part of thechassis with the tall rack.
Thethree top bays are meant for optical drives only. The six bottom onescan accommodate either 5-inch devices or one or two cages for HDDs.
Optical and other devices are fastened in the 5-inch bays in the most classic way: with screws, without rails or anything.
You don’t have to tear the brackets off: they are fastened with screws to the front part of the rack.
Eachcage is fastened to the rack by means of four thumbscrews on each sideof the case which is not convenient as you have to remove both sidepanels to take the cage out (by the way, you take it out from the frontof the case). You have to delve into the system case when dealing withthe cages anyway because there is a fan in the front part of each cageand the fan’s power connector goes into the interior of the system case.

Three HDDs can be installed in each cage and there are large enough gaps between them. They should be cooled properly.
TheHDDs are secured with two long screws on each side of the cage. Don’tlose the screws – it won’t be easy to find a replacement for them.
Ifyou want to limit yourself to three (or fewer) HDDs, you can installthem all into the bottom cage. Then you can attach a plastic carcassfor the installation of an additional 120mm fan to the top of the topcage. This fan will be driving the air along the graphics card, coolingthe latter. This opportunity may be useful for systems with twographics cards.
Thedeveloper didn’t forget about floppy drives and card-readers. You caninstall them using plastic rails and a special bracket for a 5-inchbay. It is good that the bracket is meshed like the others and won’tbecome a conspicuous element of the front panel.
Ifyou’ve got a very long graphics card, you can fasten the includedplastic piece to the front rack and use it as a support for the back ofthe card. That’s a nice trifle, but not quite properly designed. Thepiece is only one, so it cannot be used for configurations with twographics cards. And the graphics card must be a specific size for youto use this thing. My card proved to be insufficiently long, forexample.
The mainboard and expansion cards are secured withscrews. You should first install the PSU, though. If you’ve got a PSUwith a 120mm fan, you should position it with the fan facing upward.Note that the PSU must have long cables – they have to reach throughthe entire case almost.
I wish the case were a couple ofcentimeters longer for more comfort. There is just too little room forcables between the back part of long expansion cards and the HDDs. Itis hard to lay the cables there normally.
I would like to show you a photo of the operating system case. Its fans are highlighted and look very beautiful.
回复  

使用道具 举报

2#
 楼主| 发表于 3-5-2009 18:58:23 | 只看该作者
提示: 作者被禁止或删除, 无法发言
光是机箱,不包括电源,MSY售价 $197,好贵啊。
不过闪光风扇,侧面观察窗,存储器滑倒,水冷支持,一应俱全,有钱的话,可以考虑组装死灰级玩家系统。

http://msy.arpatubes.net/display.php?type=product&query=15947
回复  

使用道具 举报

3#
发表于 3-5-2009 21:47:19 | 只看该作者
我更喜歡p系列...902和1200有點像,900是第一代設計
回复  

使用道具 举报

您需要登录后才可以回帖 登录 | FreeOZ用户注册

本版积分规则

小黑屋|手机版|Archiver|FreeOZ论坛

GMT+11, 17-11-2026 23:34 , Processed in 0.030181 second(s), 19 queries , Gzip On, Redis On.

Powered by Discuz! X3.2

© 2001-2013 Comsenz Inc.

快速回复 返回顶部 返回列表